11/23/2023 0 Comments Aws efs mount command hangs![]() Mounting EFS on instance launch using the launch wizard When you do this, consider factors such as cross-Availability Zone data transfer charges, and latency. Note: You can mount your file system using an IP address of a mount target in a different Availability Zone than the client (Amazon Elastic Compute Cloud (Amazon EC2)). com:/ /mnt/efs nfs4 defaults,_netdev,nofail 0 0 # mount -aįor various mounting options using the mount helper, see Automatically mount EFS using /etc/fstab with EFS mount helper. Modify the parameters in fstab as needed for your configuration. Using efs-utils fs-xxxxxxxx:/ /mnt/efs efs _netdev,nofail,noresvport,tls,iam 0 0 Run the following commands to make an entry in /etc/fstab so that the EFS mount persists on reboot: # vim /etc/fstab If the mount point is busy, then use the -l parameter with the umount command: $ umount -l /mnt/efs Auto-mounting a file system using /etc/fstab Run the following command to unmount the file system: $ umount /mnt/efs Note: Edit the preceding commands as required by replacing the file system id, mount point, DNS, IP address, and so on. Run the following command to mount using an IP address: $ sudo mount -t nfs -o nfsvers=4.1,rsize=1048576,wsize=1048576,hard,timeo=600,retrans=2,noresvport mount-target-ip:/ ~/efs-mount-point Connect to the instance through SSH or Session Manager and run the command you copied in step 6: $ sudo mkdir -p /mnt/efs Copy the command under using the NFS mount helper.ħ. After installing the nfs-utils package, navigate to the EFS console.Ħ. Ubuntu-based distributions $ sudo apt install nfs-commonĢ. RHEL and CentOS-based distributions $ sudo yum -y install nfs-utils Run the following command to install the nfs-utils package: Note: Edit the preceding commands as required by replacing the file system id, mount point, and so on. Connect to the instance through SSH or AWS Systems Manager Session Manager and run the command you copied in step 6: $ sudo mkdir -p /mnt/efs Copy the command under using the EFS mount helper.ħ. Select the file system that you want to mount.Ħ. After the efs-utils package is installed, open the EFS console.Ĥ. Other Linux distributions $ sudo yum -y install git build/amazon-efs-utils*deb./build-deb.sh Ubuntu and Debian-based distributions $ sudo apt-get -y install. Run the following command to install the efs-utils package:Īmazon Linux or Amazon Linux 2 $ sudo yum install -y amazon-efs-utils ![]() I cannot figure out where to specify outbound rule for ECS service or task.To mount your Amazon EFS file system, you can either install the nfs-utils package or the efs-utils package. I've mounted the volume from an ec2 instance in the same VPC, all good. ![]() : unsuccessful EFS utils command execution code: 1įile system Id is correct. Failed to import necessary dependency botocore, please install botocore first. Attempting to lookup mount target ip address using botocore. When starting the task from ECS Console, I'm getting this error : ResourceInitializationError: failed to invoke EFS utils commands to set up EFS volumes: stderr: Failed to resolve ".com" - check that your file system ID is correct, and ensure that the VPC has an EFS mount target for this file system ID. Trying to launch a Fargate task that uses an EFS Volume.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |